Turning metrics and position maps

For clubs on STATSports Pro Series, Underdog reads the raw 10 Hz GPS stream each unit records. As well as speed, that stream has the player's position ten times a second, which gives two extra things: HIT (how hard players turn) and position maps (where on the pitch they spent their time and did their running).

Both are a trial. An admin turns them on in Settings → Features → Turning metrics (trial). They are for coaches and admins, except one part: players see their own Where you played on their match page in the app (below).

HIT — High Intensity Turning

A cut or a sharp turn at speed is hard work that distance and sprint counts miss. HIT measures it from the change in direction between GPS fixes.

  • HIT load — all the hard turns added up, harder turns counting for more. The main number.
  • HIT — the number of hard turns.
  • HIT per minute — the count over the minutes played, so a sub and a full game can be compared.

You'll find them on the athlete's session page (Turning tiles), the squad session page (columns for the whole session, game only and activities only), the athlete's session history, the trajectory under the session signature, and as a Turns (HIT) layer in the video export.

The thresholds come from RunDog and haven't yet been checked against video on Pro Series data, so treat the numbers as a guide while the trial runs.

Position maps

Each map is the GPS's own location drawn on a satellite view. Heat (the default) shows it as a smooth heatmap, pale to deep orange; 9 m grid shows it as 9 m squares. Pick a layer:

  • Time — where they spent their time.
  • HSR — where their high-speed running happened.
  • Sprint — where their sprint distance happened.
  • HIT — where their hard turns happened.

Use the buttons above the map to look at the whole session, the game, each half, the activities or one activity block. These follow the match timing and training activity split you've recorded.

Movement maps have their own page, so the session pages stay quick to open. On a squad session (GPS → Sessions → open a session) press Movement maps → Open, or Movement map → Open on a player's own session page. Pick any player in the session to see their map; Their full session → goes back to that player's session page.

Above each map are that player's numbers for the part of the session you've picked: time, distance, HSR, sprint distance and HIT. A blue dot marks their average position. For a match, a small table splits their whole-session distance, HSR and sprint distance into on the pitch and off the pitch (warm-up, half-time, touchline).

Marking the pitch. For a match, the thirds, channels, running direction and the on / off the pitch split all need the real pitch. The first time you open a match played on a ground Underdog doesn't know, press Mark this pitch and drop a pin on each corner (the map opens over where the game was played). Give it a name and save. Every later match on that ground picks it up by itself: a pitch is used when most of the squad's game running is inside it. Pitches you've already set up for the small-sided game planner count too. The marked pitch is the dashed outline.

Your club's pitches live on Settings → Pitches. Add the grounds you play and train on there ahead of time, rename them, or delete one. The same list is used by the small-sided game planner.

Find your ground. Above the map there's a list of every GAA ground. Search by ground, club or county, or pick a county. Grounds marked Outline ready bring their four pins with them: check them and save, and the ground is added to your club's pitches. For a ground marked Not marked yet, the map goes there and Underdog asks OpenStreetMap for the pitch outline. Check the pins sit on the corners of the playing area (some outlines follow the fence rather than the lines) and drag any that are off. If there are several pitches nearby, press Try the next pitch. Not in the list? Search the map and drop the pins yourself.

Grounds with more than one field. Many clubs have a main pitch and a second or third field. A ground can hold an outline for each one: pick the ground and it lists its fields (Dr. Hyde Park, Dr. Hyde Park – Pitch 2), or choose A different field here to mark another. OpenStreetMap then starts on a field that isn't marked yet.

Shared grounds. County grounds and other main venues are marked once for every club, so an away match there is framed without anyone marking it. Your club's own pitches always come first; a shared ground is used only when none of yours holds the game. When you mark a ground, Share this ground with all clubs is ticked for you. Underdog checks it before other clubs see it, and your club uses it straight away.

Where on the pitch (matches)

For a match with the halves recorded, Underdog works out which way the team attacked in each half from where the goalkeeper played (the middle of where they were, so coming out for a ball doesn't move it), checked against the full backs and full forwards. An arrow on each half's map shows it. Then, for the game — or one half at a time (pick Game, 1st half, 2nd half or extra time above the pitch). If a coach marked the quarters in Match timing, each quarter (Q1–Q4) gets its own map and pitch view too; without them there are no quarters, only halves:

  • The pitch — a drawing of the pitch with the team attacking up the page, split into thirds and channels. Each of the nine zones is shaded by its share of the measure you pick (time, distance, HSR, sprint, hard turns), with the figure in it; hover a zone for all four numbers.
  • Thirds and channels — bars beside and under the pitch: the share in the defensive, middle and attacking thirds, and in the left, centre and right channels, as the team faces the goal it's attacking.
  • Average position — a blue dot on the pitch (their line's average is a dashed ring), and in words ("middle third, left").
  • Running direction — a circle split by two dashed lines at 45° into four wedges: towards goal (top), back towards their own goal (bottom) and across (left and right, which count together). Each wedge is shaded by its share of the HSR (or sprint) distance, with the figure written in it. A run goes in the wedge its straight start-to-end line points into. Only runs that start on the pitch are counted, the same as the thirds and channels; the note under the circle says how much started off the pitch or had no clear direction, so the figures square with the rest of the page.
  • Show the numbers — the same figures as tables.
  • Game · one direction — a map with both halves turned so the team attacks the same way, with the thirds and channels drawn on as white lines and each zone's figure for the layer you've picked: share of time on the pitch, HSR or sprint metres, or hard turns.

If the keeper wasn't wearing a unit, the full backs and full forwards decide. If the halves come out the same way, or there's no reading, the card says Check the direction. Flip direction reverses it for everyone in that session.

When the map changes after the session

If you record the halves or the activity split after the GPS has come in, the maps are redrawn the next time you open the session, as long as it's within a week. After that the detailed GPS trace has been cleared, so the page tells you the per-part maps may be out of date. Settings → STATSports Pro Series → Work out HIT and position maps for past sessions downloads the stream again from STATSports and redraws them. The same button adds HIT and maps to sessions imported before they existed.

What's kept

A position puts a person at a place and time, so Underdog keeps as little as it can:

  • The second-by-second position trace is stored next to speed and heart rate and cleared after 7 days, with the rest of the detailed stream.
  • After that only the 3 m squares are kept: how long, and how much running, in each one. Not the order they were visited in. Each high-speed run also keeps where it ended relative to where it started (for its direction), not the path in between.
  • Maps are shown only to the club's coaches and admins, and only for players whose GPS data the club can see. They fall under the same GPS consent as every other session metric.

Where you played (players, in the app)

With the trial on, a player's match page in the app gets a Where you played section: the same pitch drawing, thirds, channels, running direction and average position as the coach sees, for the game or one half (or quarter) at a time — but no map. It's worked out on the server from the squad's maps (that's how the attacking direction is known), and only the player's own numbers come back, plus their line's average position. A player never sees a team-mate's map. If the direction couldn't be read for every half, the section says attacking and defensive may be the wrong way round.

Not yet

Season maps and the map itself for players in the app are planned for later.